Nailing Tongue And Groove Siding

The stales are installed every 12 into the tongue of the board and are covered and hidden by the next boards groove is installed.

Nailing tongue and groove siding.

Tongue groove installation tongue and groove siding can be installed horizontally or vertically. To ensure that the nail gets into the groove where it will be hidden it must be inserted at an angle. Drive the nails through the shoulder of the tongues into the framing at about a 45 degree angle. One of the cool things about tongue and groove walls is that you can use a technique called blind nailing if you do it properly you won t have any nail heads showing or holes to fill.

This is called blind nailing the only location that we installed fasteners in the face of the cedar was at the top where a trim board was covering it. May 30 2018 tongue and groove or lapped sidings generally have a rustic cabinlike appearance. Lay in the following course of tongue and groove board next to the first. The siding can be made of many different types of wood and generally give a rustic cabin like appearance to a wall.

Siding up to 6 inches wide can be blind nailed with one siding nail per bearing toe nailed through the base of each tongue. Wider siding should be face nailed using two nails per piece. The next grooved edge will hide the nail holes. Because the nail goes in at an angle and needs to be sunk a nail gun is a better option than a hammer.

Rest a piece of scrap wood next to the board s tongue and hit it with the hammer if the second board resists placement directly against the first board with no gap. With tongue and groove paneling the nails are inserted into the groove and hammered to below the surface. In horizontal application start at the bottom and work up with the groove edges facing downwards. A variety of siding types fit together by means of tongues and grooves or over and underlapping edges.